darker technotes.
Categories
Latest News
- Curiously Strong Power Supply Design
- ATTiny44 Based Shifty VU Meter Controller (MAKE2008)
- Curiously Strong TriAmp Speaker Selection
- Grow LED Array Rev.2 Results AKA Why Rev.3
- Grow LED Array Prototype Rev. 2
- MAKE 2008 Grow LEDs Array Prototype Design
- Stereo Audio IO Landing Pad for Olimex SAM7-H256: Assembled
- Jabra BT125 Bluetooth Headset Teardown
- ASUS Tech Support Confirms Two Year Hardware Warranty Details. I’m Getting 2GB.
- Booting An ISOLINUX LiveCD From Eee PC’s SD Card Reader
Monthly archives
Search
Jabra BT125 Bluetooth Headset Teardown
Two very small torx screws, edge snaps, some plastic hooks at the end with mating feature on the opposite chassis piece. Speaker is insulated from the main chassis by a rubber-like pad. The mic is built into a pod made of the same rubbery material, which when mounted fits flush with the outer chassis. Torx screws came out with a clipped xacto blade tip.
Going to swap the blue 0603 LED for a red one. Maybe amber. Will possibly swap the 0402 resistor with a larger one. Try to kill the sniper beacon blink effect. Alternative is a thick film or thin paper light filter behind the translucent white button.
The grid is .250″.
Posted by rmrubin 
February 2008